EnviroTabs Directions for Usage

EnviroTabs® burns off carbon deposits and catalytically causes a chemical reaction to happen at a lower temperature. The fuel particles begin to combust at temperatures as low as 200º C, as opposed to 600° C. This chemical reaction allows the impurities and the hard carbon deposits to completely burn off. 

Before using EnviroTabs establish a base mileage.

Find out how big your fuel tank is. DO NOT guess. 
Check with your owners manual, on line or with your Dealer. 
You cannot dose correctly without knowing your tank size.

Fill up your tank WITHOUT EnviroTabs, and calculate the miles per gallon you are currently receiving. You wil want to do this for at least two or three fill-ups to establish an average.

NOTE: DO NOT USE THE VEHICLE’S ON BOARD COMPUTER for any miles per gallon (MPG) calculations. The computer may not be accurate because it uses algorithms to estimate the mileage per gallon calculation.

To calculate MPG for a full tank of gas:
Start with a full tank of Gas.

When your tank is almost empty, fill up the tank

Note the Mileage for the END:..............................................._____________

Number of gallons of fuel purchased ( ): ................................______. _____

END mileage minus START mileage = Total Miles driven during this tank of gas. 

Total Miles divided by the Number of Gallons purchased = MPG

If possible get an emmisions test using a tail pipe gas analyzer. NOT the test that is done under the dash. This is the best way to tell that the product is working in lowering your emmissions.

Measuring the effectiveness of EnviroTabs

In addition to measuring the increase in gas mileage, you may want to consider measuring horsepower (using a dyno), emissions from the tailpipe (using a flu gas analyzer) or simply noticing the increase in power after your first few tanks with the EnviroTabs in.

All of these signs are proof-positive that the EnviroTabs are working.

Once you’ve established your base / average Miles Per Gallon WITHOUT EnviroTabs you’re ready to start measuring your fuel savings.

For your convenience, there is a worksheet inside your Test Drive Kit, available in your back office, or from you Greenfoot Global Distributor to assist you with this process.

NOTE: For additional savings if you use Premium fuel, you can switch to Regular fuel instead.

Step 1: Double dose the EnviroTabs for the first two tanks full.

At the end of the first tank, it would really help accuracy to disconnect the positive cable from the vehicle’s battery and touch it to earth ground for 10-15 minutes. 

This will reset the vehicle's computer (ECU / ECM) and allow it to recognize the change in the sensor system so that it recognizes the catalyst is in the fuel. This is not critical, but very helpful.

Although you will probably see significant results in your horsepower and decreased emissions after the first couple of tanks, DO NOT EXPECT ANY RESULTS on the first two tanks for an increase in fuel mileage. The fuel savings begin take anywhere from three (3) to six (6) tanks.

Please be patient. This product works in all combustion engines every single time. This product works with any fuel type (gas, diesel, bio-diesel, and ethanol).

Step 2: FROM THE SECOND TANK ON - ONLY TREAT THE AMOUNT OF FUEL YOU ARE ADDING TO EACH TANK.

Example - If you have a 25 gallon tank and are filling up with 15 gallons, treat only the 15 gallons, NOT the 25 gallons. 
Hence you will use only one EnviroTabs.

If you’re not sure, always go with a lesser amount. 
The product will last you longer and give you better results. You might want to pick up an inexpensive pill cutter from your local pharmacy to help cut the EnviroTabs in half.